1)<\/strong> Open the command prompt as Administrator. Search \u2018cmd\u2019 and right click on cmd then select \u2018Run as administrator<\/strong>\u2019 as below.<\/p>\n 2)<\/strong> Type following commands \u2013<\/p>\n netsh winsock reset catalog<\/strong> (Reset WINSOCK entries to installation defaults) 3)<\/strong> Reboot the computer.<\/p>\n The Problem:<\/strong> In the main this will repair the system, though we may find ourselves in the situation where we have to add those static routes again by \u2018route add\u2019 command.<\/p>\n 4)<\/strong> If you are still facing the issue and your Windows 10 or 8.1 can\u2019t connect to internet and other local network resources, continue below steps.<\/p>\n The following few more netsh commands may fix the problem. Make sure you are entering below commands in command prompt which was opened as Administrator.<\/p>\n netsh int tcp set heuristics disabled<\/strong><\/p>\n netsh int tcp set global autotuninglevel=disabled<\/strong><\/p>\n netsh int tcp set global rss=enabled<\/strong><\/p>\n These command are good commands to use to make your Windows 10 network faster.<\/p>\n 5)<\/strong> If your wired network is fine, but you are having trouble in wireless network only, then you can change the power options and wake up the WiFi Adapter.<\/p>\n Right click on the WiFi adapter and select Properties.<\/p>\n Click on \u2018Configure<\/em>\u2019.<\/p>\n <\/p>\n![\"\"](\"http:\/\/help.sealionshipping.co.uk\/wp-content\/uploads\/2017\/03\/New-Picture.bmp\")
<\/a><\/p>\n
\nnetsh int ipv4 reset reset.log<\/strong> (Reset IPv4 TCP\/IP stack to installation defaults)<\/p>\n<\/a><\/p>\n
\nOne of the above reset command removes all persistent static route entries from your Windows 10 computer.<\/p>\n<\/a><\/p>\n